Many production machines want to have proper braking when parking, so that moving parts can stop quickly. Parking brakes have various methods such as mechanical braking and electric braking. Energy braking is a widely used electrical braking method.
The energy consumption braking is to cut off the running motor from the AC power supply and immediately turn on the DC power supply. When the stator winding is connected to the DC power supply, the DC current will generate a static DC magnetic field in the stator. The rotor is in the magnetic field due to inertia. The inner rotation and the induced potential in the rotor conductor cause an induced current to flow. And interacting with the constant magnetic field consumes the inertia energy of the motor rotor to generate the braking torque, causing the motor to decelerate rapidly and finally stop rotating.
1. Close the air switch QF to connect the three power supplies.
2. Press the start button SB2, the contactor KM1 coil is energized and self-locking, and the main contact closing motor is connected to the three-phase power supply to start the operation.
3. When it is necessary to stop, press the stop button SB1, the KM1 coil is de-energized, and all the main contacts release the motor out of the power supply.
4. At this time, the contactor KM2 and the time relay KT coil are energized and self-locked, and the KT starts timing. The KM2 main contact is closed to connect the DC power to the stator winding of the motor, and the motor quickly stops under the energy consumption braking.
In addition, when the normally closed contact of the time relay KT is turned off, the contactor KM2 coil is de-energized, the KM2 normally open contact is disconnected from the DC power supply, the power supply is disconnected from the stator winding, and the energy consumption brake is terminated in time to ensure accurate stop. .
5. The overload protection of the circuit is completed by a thermal relay.
6. Interlocking link:
(1) The KM2 normally closed contact is connected in series with the KM1 coil circuit, and the KM1 normally closed contact is connected in series with the KM2 coil circuit. It is guaranteed that the KM1 and KM2 coils cannot be energized at the same time, that is, when the motor is not separated from the three-phase AC power source, the DC power source cannot be connected to the stator winding.
(2) The normally closed contact of button SB1 is connected to the KM1 coil circuit, and the normally open contact of SB1 is connected to the KM2 coil circuit. This is the interlock of the button and also ensures that KM1 and KM2 cannot be energized at the same time, and the above interlocking touch Points play the same role.
7. The DC power supply adopts a diode single-phase bridge rectifier circuit, and the resistor R is used to adjust the braking current and change the braking force.
Motor full-wave energy consumption brake control wiring diagram
The Friction Disc is a kind of Printer Accessories.
The cartridge is irradiated by laser beam to adsorb toner, and then the toner is hot pressed by fixing roller for printing. In this process, there will be part of toner residual, which can not be "granules returned to the warehouse"; Automatic cleaning function is not adsorbed new toner particles and directly print, will remain toner away, fully ensure the next printing effect. And the Plate-Grid plays an important role. When high voltage generator to a high voltage electrode, wire electrode with reseau formed between a strong electric field, and release the corona, wire electrode and the photosensitive drum ionizes the air between the air ions migrate to the drum surface, make the photoconductor (drum) surface is full of charge, so can spare toner "adsorption to warehouse", so as to save toner, The purpose of reducing environmental pollution.
High Accuracy Friction Disc,Semi-Etching Surface Friction Disc,Drive Shaft Parts ,Printer Friction Disc
SHAOXING HUALI ELECTRONICS CO., LTD. , https://www.cnsxhuali.com